Full manual PDF
ON/OFF TIMER with an hours remaining display (COUNT UP-DOWN ON/OFF TIMER)
Check that the clock is correct. If not, set the clock to the present time.
-
Press and hold
or 
for about 5 seconds, when signal indicater ( 
) blink, release your finger from the button.
[For ON TIMER]
-
“
” appears on the LCD.
-
“
” blinks.
-
“
” disappear from the LCD.
[For OFF TIMER]
-
“ ” appears on the LCD.
-
“
” blinks.
-
“ ” disappear from the LCD.
-
“
-
Press
until the time setting reaches the point you like.
- Each pressing of the button increases or decreases the time setting by 1 hour.
- The time can be set between 1 and 12 hours.
-
Press or again.
-
“
” and “ 
”, and setting time appear on the LCD.
- The TIMER lamp lights orange.
- To change the display mode from COUNT UP-DOWN ON/OFF TIMER to 24 HOUR ON/OFF TIMER, repeat STEP 1, and continue from STEP 2 of “24 HOUR ON/OFF TIMER”.
-
Timer display mode cannot be changed while “ ” or “ ” are blinking. Press or to stop the blinking.
Display -
“
NOTE
Notes on COUNT UP-DOWN ON/OFF TIMER
- After setting, the time displayed on the LCD will automatically count down by 1 hour for every 1 hour that passes. For example, if the OFF TIMER is set to 3 hours, the display will change as follows: 3hr → 2hr → 1hr → blank (OFF)
Switching between ON/OFF TIMER display modes (24 hour clock and hours remaining display)
- When changing timer display modes (from 24 HOUR ON/OFF TIMER to COUNT UP-DOWN ON/OFF TIMER or vice versa), the timer cancels. The timer must be set again to activate it.
