Preparation before operation

All content

Preparing the remote controller

CAUTION

Incorrect handling of batteries can result in injury from battery leakage, rupturing or heating, or lead to equipment failure.

If the alkaline solution from the batteries should get in the eyes, do not rub the eyes. Instead, immediately flush the eyes with tap water and seek the attention of a medical professional.
Keep batteries out of the reach of children. In the event that batteries are swallowed, seek the immediate attention of a medical professional.
Do not expose batteries to heat or fire. Do not disassemble or modify batteries. The insulation or gas release vent inside the battery may be damaged, resulting in battery leakage, rupturing, or heating.
Do not damage or peel off labels on the batteries.

NOTE

To avoid possible injury or damage from battery leakage or rupturing, remove the batteries when not using the product for long periods of time.
The standard replacement time is 1 year. Both batteries should be replaced at the same time. Be sure to replace them with new size AAA. LR03 (alkaline) batteries.
When battery power has run out, “ ” will begin blinking as an alert that the batteries need replacing. In some cases, when battery consumption is accelerated owing to usage conditions, signal reception may decline before “ ” begins blinking.
The batteries supplied with the remote controller are for initial operation. The batteries may run out in less than 1 year.
The usable period of the batteries may be short depending on the manufacture date of the air conditioner.

Do not drop the remote controller. Do not get it wet.
Dust on the signal transmitter or receiver will reduce the sensitivity. Wipe off dust with a soft cloth.
Signal communication may be disabled if an electronic-starter-type fluorescent lamp (such as an inverter-type lamp) is in the room.
Consult your dealer if that is the case.
If the remote controller signals happen to operate another appliance, move that appliance to somewhere else, or consult your dealer.

Preparing the remote controller holder

Choose a place from where the signals reach the unit.
Fix the holder to a wall, a pillar, or similar location with the screws supplied with the holder.
Place the remote controller in the remote controller holder.

Attaching the small filters (Air quality filter (enzyme blue with PM2.5))

If attaching the separately sold filters, attach them before turning the power on.

Details

Turning on the circuit breaker

After the power is turned on, the flap of the indoor unit opens and closes once to set the reference position.