Adjusting the airflow direction

You can adjust the airflow direction to increase your comfort.

-
Always use the remote controller to adjust the angles of the flaps and louvres.
- If you attempt to move the flaps and louvres forcibly by hand when they are swinging, the mechanism may be damaged.
- Be careful not to place your fingers inside the air outlet, as a fan is rotating at high speed.
To start auto swing
Up and down airflow direction
Press
.
- ”
” appears on the LCD.
-
The flaps (horizontal blades) will begin to swing.
Right and left airflow direction
Press
.
- ”
” appears on the LCD.
-
The louvres (vertical blades) will begin to swing.
NOTE
Notes on airflow direction setting
-
The movable range of the flaps varies according to the operation mode. Refer to the picture below.
Movable range of the flaps
Close
3-D airflow direction
Press
and
.
- “
” and “
” appear on the LCD.
- The flaps (horizontal blades) and louvres (vertical blades) will move alternately.
-
To cancel 3-D airflow, press either
or
again.
The flaps (horizontal blades) or louvres (vertical blades) will stop moving.
NOTE
Note on 3-D airflow
- Using 3-D airflow circulates cold air, which tends to collect at the bottom of the room, preventing areas of cold developing.
Close
To set the flaps or louvres at the desired position
- This function is effective while the flaps or louvres are in auto swing mode.
Press
and
when the flaps or louvres reach the desired position.
- In the 3-D airflow, the flaps and louvres move in turn.
-
“
” or “
” disappears from the LCD.
Close